BIGTREETECH SKR mini E3 V1.2 Control Board 32Bit With TMC2209 UART Driver 3D Printer parts skr v1.3 E3 Dip For Creality Ender 3

€66,99

          Dear customer, On September 29 start sending version is BTT SKR mini E3 V1.2.  If you have any questions about the logistics information of the order,...

 

1.YOU MAY INTEREST

 

 

4.ITEM DESCRIPTION

 

 

Dear customer,

On September 29 start sending version is BTT SKR mini E3 V1.2. 

If you have any questions about the logistics information of the order, please contact us at AliExpress, we will tell you about the package.

 

If the motherbord your receive version is BIGTREETECH-SKR-mini-E3 V1.0, please check the BIGTREETECH-SKR-mini-E3 V1.0 document which is in the firmware and hardware files.

If the motherbord your receive version is BTT SKR mini E3 V1.2, please check the BTT SKR mini E3 V1.2 document which is in the firmware and hardware files.

 

The factory-installed motherboard will be equipped with firmware for testing (Ender3 models), which can be used directly or as needed.

 

Test video:

https://www.youtube.com/watch?v=-XUQKQnUNig

 

Introduction:

BIGTREETECH SKR-mini-E3 motherboard is the 3D batting of ShenZhen BigTree Technology CO.,LTD

An ultra-silent, low-power, high-quality 3D printer master board launched by the printing team.

Specially for Ender 3 printer to update.

 

More detailed information about SKR MINI E3 you can visit this website:
 
 
 
 
 

5.ITEM SHOWS

 

 

1 (1)1 (2)1 (3)1 (4)1 (5)1 (6)1 (7)2 (1)2 (2)2 (3)2 (4)2 (5)3_013_063_023_033_04

Dust or wipe clean with a cloth dampened with water once a week. Be sure not to leave water spots on the surface. These water spots will dry and could possibly leave permanent marks. Clean stains/spots using the following steps: Dampen a soft cloth with a mixture of hot water and liquid dishwashing detergent. Wring the cloth as much as possible to remove excess liquid. Rub the surface lightly in a circular motion. Dry the surface immediately with a clean, soft towel.